![]() ![]() The sound processor should automatically detect the presence of the Roger receiver. Step 2: Switching on Ask your patient to put on the sound processor and switch it on. ![]() Attach the Roger 14 to the sound processor. Attach the adapter to the sound processor. Step 1: Attach receiver Roger X Switch all equipment off. These settings have been thoroughly tested with CI recipients. Module setting Recommended EasyGain AutoConnect statusĬochlear Nucleus 6 / 5 Setting 9 0dB OFF This will ensure that the Roger X output impedances match the input impedance of the sound processor. Click Manage, scroll to CI module then click OK. Turn Roger inspiro on, hold it close to Roger X (less than 10 cm/4 inches) and select the function Check. A Roger inspiro is required for programming Roger X.ġ. Model Sound processor setting Cochlear Nucleus 6 / 5 Set Mixing Ratio to 1:1 and select AutosensitivityTM + ADRO configurationįor Roger 14, no pre-programming is required. This will ensure maximum benefit from the Roger system. Pre-fitting Program the sound processor with the recommended settings according to the table below. 2 Build Standard C or higher.įitting Guide | Roger and Cochlear sound processors Nucleus 5 and Nucleus 6 2 Accepted by the Journal of the American Academy of Audiology. Roger 14 Cochlear Euro Accessory Adapter and Roger XġJace Wolfe (2013), Evaluation of speech recognition of cochlear implant recipients using a personal digital adaptive radio frequency system. Jace Wolfe of Hearts for Hearing Foundation, Oklahoma City, revealed that the use of Roger systems in combination with cochlear implants resulted in significant improvements in speech recognition at high noise levels (70 to 80 dB (A)) over fixed gain FM and Dynamic FM technologies (see Set-up The table below shows what is required to connect the sound processor to a Roger receiver.Ĭochlear Nucleus 6 (CP910) / Nucleus 5 (CP810)2 Roger and Cochlear sound processors Nucleus 5 and Nucleus 6 This guide provides detailed information on how Roger receivers should be used with Cochlear sound processors Nucleus 5 (CP810) and Nucleus 6 (CP910) to achieve the best possible performance. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |